TM 9-2320-273-20
EXTERIOR LIGHTING.
5-47. CLEARANCE LAMPS MAINTENANCE (Continued).
LOCATION/lTEM
ACTION
REMARKS
5. Lamp base (10).
Remove.
6. Gasket (11).
Remove.
Discard if cracking or tears
are evident
7. Wire connector (12).
Disconnect.
8. Wire connector ( 12).
Connect.
9. Gasket (11).
Install.
10. Lamp base (10).
Aline mounting holes.
11. Two screws (8) and
Install and tighten.
ground washers (9).
12. Bulb (7).
Install.
13. Gasket (6) and lens (5).
Replace.
14. Screw (3) and seal (4).
Install and tighten.
15. OPERATION switch (2).
Set to NORMAL.
16. LAMP switch (1).
Pull ON; verify that
clearance lamps come on.
17. CLEARANCE button (13).
Press and verify that
clearance lamps go OFF.
NOTE
Upon completion of this task, apply a
suitable windshield sealant over screws
(8) to prevent water entry.
5-158 Change 1
