TM 9-2320-273-20
EXTERIOR LIGHTING.
5-46. REAR LAMP ASSEMBLY MAINTENANCE (Continued).
LOCATION/lTEM
ACTION
REMARKS
1. Four screws (15).
Remove
2. Lens (14).
Remove.
3. Gasket (13}.
Remove.
Discard if cracking or tears
4. Bulb (12).
Remove.
are evident.
5. Bulb (3).
Remove.
6. Four screws (10).
Remove.
7. Terminal cover (9).
Remove.
NOTE
Remove grease from wire connections
with cleaning solvent before proceeding
to next step.
8. Three screws (6) and
Remove.
washers (7).
9. Three wires (8).
Remove.
10. Two nuts (4) and
Remove.
washers (5).
11. Rear lamp assembly (11).
Remove.
12. Rear lamp assembly (11).
Aline mounting studs and
install.
13. Two washers (5) and
Install and tighten.
nuts (4).
14. Three wires (8).
Replace on rear lamp assem-
bly according to figure.
15. Three washers (7) and
Install and tighten.
screws (6).
16. Terminal cover (9).
Fill with bearing grease;
then, aline and install.
5-152