TM 9-2320-273-20
EXTERIOR LIGHTING
5-44. HEADLAMPS MAINTENANCE (Continued).
LOCATION/lTEM
ACTION
REMARKS
3. Three short screws (13).
a. Remove
b. Remove headlamp retainer (12).
4. Headlamp (11).
Disconnect wire connector
(10) and remove.
5. Six screws (9).
Remove
6. Headlamp base (8).
Remove.
7. Two nuts (5), one bolt (6)
Remove three headlamp wires (7)
and three washers (4).
from terminal board (3).
8. Three wires (7).
Install on terminal board (3).
9. Three washers (4) and two
Install and tighten on
nuts (5), and one bolt (6).
terminal board (3).
10. Headlamp base (8).
Install with six screws (9) and
aline.
11. Wire connector (10).
Connect to headlamp (11)
and insert headlamp into
base (8).
12. Headlamp retainer (12).
Install with three short screws
(13).
13. Rim cover (14).
Install with screw (15).
14. OPERATION switch (2).
Set to NORMAL.
15. LAMP switch (1).
Pull ON to second position.
16. HEADLAMP (11).
Observe that headlamp comes ON.
17. DIMMER switch (16).
Press and verify that HIGH beam
comes ON. Press again and verify
that LOW beam comes ON.
5-144
