TM 9-2320-273-20
ELECTRICAL SYSTEM.
.
5-31.1. WIRING HARNESS REPAIR (Continued).
LOCATION/lTEM
ACTION
REMARKS
B. CIRCULAR CONNECTOR RECEPTACLE REPAIR.
NOTE
Use this procedure to repair any one
of the connector receptacles.
1. Connector plug (1).
Unscrew and remove from
connector receptacle (2).
2. Hexagon nut (6) and
Unscrew and remove from
Iockwasher (7).
connector receptacle (2).
3. Connector receptacle (2).
Remove from bracket (8).
4. Terminal (9).
Using contact removal tool (4) If connector receptacle (2) is
or (5), pull out from rear side
being replaced, repeat this step
of connector receptacle (2).
until all terminals (9) have
been removed. Be sure to tag
wires (10).
5. All parts.
Clean and inspect.
If any terminals (9) are dam-
aged, do steps 6 and 7.
6. Terminal (9).
Remove from wire ( 10) and
discard.
7. New terminal (9).
Using crimping tool (3), install Be careful not to damage ter-
onto wire (10).
minal (9) during this step.
8. Terminal (9).
Push into rear end of con-
If connector receptacle (2) is
nector receptacle (2) until
new, repeat this step until all
it snaps into place.
terminals (9) have been in-
stalled. Check the mating
side of connector receptacle
(2) to make sure all terminals
(9) are on the same level.
9. Connector receptacle (2).
a. Position on bracket (8).
b. Secure with hexagon nut
(6) and Iockwasher (7).
10. Connector plug (1).
Line up slots with pins on con-
nector receptacle (2) and screw
on until it clicks into place.
5-92.2 Change 2
