TM 9-2320-273-20
ELECTRICAL SYSTEM.
5-31.1. WIRING HARNESS REPAIR (Continued).
LOCATION/ITEM
ACTION
REMARKS
A. CIRCULAR CONNECTOR PLUG REPAIR.
1. Connector plug (1).
2. Terminal pin (12).
3. All parts.
4. Terminal pin (12).
5. New terminal pin (12).
6. Terminal pin (12).
7. Connector plug (1).
NOTE
Use this procedure to repair any one
of the connector plugs.
Unscrew and remove from
connector receptacle (2).
Using contact removal tool
(4) or (5), pull out from rear
side of connector plug ( 1).
Clean and inspect.
Remove from wire (11) and
discard.
Using crimping tool (3),
install onto wire (11).
Push into rear end of con-
nector plug (1) until it snaps
into place.
Line up slots with pins on
connector receptacle (2) and
screw in until it clicks into
place.
If connector plug (1) is being
replaced, repeat this step
until all terminal pins (12)
have been removed. Be
sure to tag wires (11).
If any terminal pins (12) are
damaged, perform steps (4)
and (5).
Be careful not to damage
terminal pin (12) during
this step.
If connector plug (1) is new,
repeat this step until all
terminal pins (12) have been
installed. Check the mating
side of connector plug (1)
to make sure all connector
receptacles (2) are on the
same level.
Change 2
5-92.1
