TM 5-2330-325-13&P
0072
INSTALLATION AND ADJUSTMENT OF WHEEL BEARINGS - Continued
NOTE
A minimum of two tabs must be bent down on tabbed washer.
11.
Bend tabs on tabbed washer (Figure 3, Item 2) against outer bearing nut (Figure 3, Item 1).
12.
Align brake drum holes with hub studs (Figure 3, Item 9) and slide brake drum (Figure 3, Item 12) onto hub
(Figure 3, Item 7).
13.
Install new cap gasket (Figure 3, Item 10).
NOTE
Only perform Step 14 if maintenance is not being performed on right-front hub.
14.
Install hub cap (Figure 3, Item 11) with six bolts (Figure 3, Item 14) and new lockwashers
(Figure 3, Item 15).
15.
For right-front hub and drum only, if hub mileage meter (Figure 3, Item 13) was removed, install hub cap
(Figure 3, Item 11) and hub mileage meter (Figure 3, Item 13) with two bolts (Figure 3, Item 14) and new
lockwashers (Figure 3, Item 15).
8
7
6
9
5
4
3
2
10
1
11
15
14
12
466-0078b
13
Figure 3.
Hub and Brake Drum Installation.
END OF TASK