TM 5-2330-325-13&P
0069
CLEANING - Continued
WARNING
Improper cleaning methods and use of unauthorized cleaning solvents may injure
personnel and damage equipment. Failure to comply may result in death or injury
to personnel. Seek medical attention in the event of an injury.
Cloths or rags saturated with solvent cleaning compound must be disposed of
using IAW authorized facilities procedures. Failure to comply may result in death or
injury to personnel. Seek medical attention in the event of an injury.
1.
Clean mud and dirt from exposed surfaces with water and a stiff brush.
2.
Remove grease and oil with cleaning compound solvent using a wiping rag. Dry thoroughly.
END OF TASK
INSPECTION
1.
Inspect for loose, missing, or damaged parts.
2.
Inspect air chamber for cracks, dents, holes, and warps.
3.
Inspect for rust or corrosion.
4.
Replace defective parts.
END OF TASK
INSTALLATION
NOTE
Ensure jamnut and slack adjuster nut are on brake chamber rod before clevis is installed.
1.
Install jamnut (Figure 2, Item 6) and clevis (Figure 2, Item 5) onto brake chamber rod (Figure 2, Item 7).
2.
Install air chamber (Figure 2, Item 8) on axle with two nuts (Figure 2, Item 4) and new lockwashers
(Figure 1, Item 3).
3.
Apply antiseizing tape to two fittings (Figure 2, Item 2) and install on air chamber (Figure 2, Item 8).
4.
Apply antiseizing tape to two air lines (Figure 2, Item 1) and connect air lines.
5.
Close all dump valves and pressurize air brake system.
6.
Check for leaks.
0069-4
02/13/2013root(maintwp)wpno(M1037)