M1070 HET ARMOR KIT
II113400
Rev. D
a. Installation
1.
Pre-assemble right side panels as follows (see Figure 3-48):
NOTE
Ensure that door hinge (3) is oriented as shown in Figure 3-48, and align holes
marked "A" with drill bushings.
a. Align right forward side panel (1) with right forward side panel (2) and install door hinge (3) and
hinge bracket (4) and secure with 12 bolts (5), flat washers (6), locknuts (7), one bolt (8), one washer (6),
and one locknut (7). Torque locknuts to 35 lb-ft.
b.
Install armor step bracket (9) and secure with two bolts (8), four flat washers (6), and
two locknuts (7). Torque locknuts to 35 lb-ft.
c. Install one 90-degree joiner bracket (10) and secure with three flat washers (6) and locknuts (7). Do not
tighten locknuts at this time.
d. Install hood clamping catch (retained from Teardown, Chapter 2) and secure with two bolts (11),
flat washers (12), and locknuts (13). Torque locknuts to 11 lb-ft.
e. Apply trim seal (14) to the assembly from the top of the hinge bracket (4) to the top of the left forward
side panel (1).
INSTALLATION 3-90
JUNE 2005