M1070 HET ARMOR KIT
II113400
Rev. D
3. Install left aft side panel assembly as follows (see Figure 3-20):
NOTE
Repositioning of 90-degree joiner brackets may be required to provide adequate
clearance while mounting the left aft side panel assembly.
a. Install 3 flat washers (1) onto each stud along left side of cab on the roof panel.
b. Using appropriate lifting device, hardware, and personnel, lift left aft side panel assembly from cab lift
brackets into position onto the cab.
c. Verify holes in left aft side panel assembly for grab handle and seat belt attachments are aligned with
holes in the cab.
d. Slide both bottom 90-degree joiner brackets firmly up into position against cab frame rail and torque
bracket locknuts to 23 lb-ft.
e. Install six flat washers (1) and locknuts (2) onto the studs of the two 90-degree joiner brackets. Do not
tighten locknuts at this time.
f.
Install eight flat washers (1) and locknuts (2) onto top row of studs connecting the 45-degree brackets to
the roof armor. Do not tighten locknuts at this time.
INSTALLATION 3-38
JUNE 2005
