TB 9-2320-360-13&P-1
A/C KIT INSTALLATION - CONTINUED
0003 00
IN-CAB COMPONENTS - CONTINUED
0003 00
WAR N I N G
Adhesives and sealing compounds can burn easily, can give off harmful vapors and are harmful to skin and
clothing. To avoid injury or death, keep away from open fire and use in well-ventilated areas. If adhesive or
sealing compound gets on skin or clothing, wash immediately with soap and water.
(c) Apply sealant to grommet (40) in interior of doghouse.
HETF00331
FINAL COMPONENT ASSEMBLY
0003 00
1.
Route A/C Compressor - Receiver/Dryer Harness Through Doghouse.
C AU T I O N
Make sure wire harness is routed away from moving parts of engine. Failure to follow this caution may cause
damage to vehicle.
N OT E
The A/C compressor receiver/dryer har-
ness connector is routed into the doghouse
before the evaporator is installed. Once the
evaporator is installed, you do not have
access to the back of the doghouse. The
harness is then secured to the A/C hoses in
the engine compartment, which are
installed from the evaporator back toward
the front of the truck.
a.
Route receiver/dryer harness (1) along right side
of engine compartment.
b.
Install plastic ties (2) as required.
449-120
0003 00-32
