TB 9-2320-360-13&P-1
A/C KIT INSTALLATION - CONTINUED
0003 00
IN-CAB COMPONENTS - CONTINUED
0003 00
N OT E
Note location of plastic ties when removing original wire 1280. Install plastic ties at same location when secur-
ing new wire 1280, provided with the kit.
Cut plastic ties as required.
(7)
Remove original wire 1280 (33).
HETF00330
(8)
Connect new wire 1280 (39) to 24-vdc magnetic switch (29).
(9)
Install cushion clip (36) in bottom of electronic control box assembly (38) with screw (34) and washer
(35).
(a) Thread remaining portion of wiring harness through grommet on doghouse ceiling in interior of dog-
house.
(b) Route wiring harness along forward wall to right side of vehicle and place end of wiring harness near
rear of doghouse where it will be installed on evaporator.
HETF00331
0003 00-31
