TB 9-2320-335-13&P
24-4. SPLASH SHIELD SUPPORT BRACKET REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Tools
Manual References
General mechanic's tool kit:
TM 9-2320-387-10
automotive (Appendix B, Item 1)
TM 9-2320-387-24P
Maintenance and repair shop equipment:
Equipment Condition
automotive (Appendix B, Item 2)
Hood raised and secured (TM 9-2320-387-10).
Materials/Parts
Maintenance Level
Three locknuts (Serial numbers 299999 and
Direct support
below) (Appendix A, Item 85)
Three locknuts (Serial numbers 300000 and
above) (Appendix A, Item 114.4)
a. Removal
1.
Remove locknut (1), washer (2), capscrew (4), washer (2), and splash shield (3) from bracket (7).
Discard locknut (1).
2.
Remove two locknuts (5), washers (6), capscrews (9), washers (6), and bracket (7) from frame rail (8).
Discard locknuts (5).
b. Installation
1.
Install bracket (7) on frame rail (8) with two washers (6), capscrews (9), washers (6), and lock-
nuts (5). Tighten locknuts (5) to 90 lb-ft (122 Nm).
2.
Install splash shield (3) on bracket (7) with washer (2), capscrew (4), washer (2), and locknut (1).
Tighten capscrew (4) to 15 lb-ft (20 Nm).
FOLLOW-ON TASK:
Lower and secure hood (TM 9-2320-387-10).
24-3