TB 9-2320-335-13&P
15-5. RIGHT CYLINDER HEAD REPLACEMENT (Cont'd)
NOTE
Use of cylinder head lifting device is optional.
1.1.
Install cylinder head lifting device (1.3) on center of cylinder head (1) with two washers (1.2) and
capscrews (1.1).
1.2.
Install cylinder head (1) on cylinder block (5) and remove two capscrews (1.1), washers (1.2), and
cylinder head lifting device (1.3) from center of cylinder head (1).
2.
Apply pipe sealing compound to threads and under heads of seventeen capscrews (3).
CAUTION
Failure to tighten cylinder head capscrews in proper torque
sequence may result in leaks or damage to cylinder head.
3.
Secure cylinder head (1) to cylinder block (5) with seventeen capscrews (3). Tighten capscrews (3) to
20 lb-ft (27 Nm) following torque sequence.
4.
Tighten seventeen capscrews (3) to 55 lb-ft (75 Nm) following torque sequence.
5.
Retighten seventeen capscrews (3) to 55 lb-ft (75 Nm) following torque sequence.
6.
Tighten seventeen capscrews (3) an additional 90 following torque sequence and mark capscrews (3).
7.
Install cold-advance switch (2) on cylinder head (1).
1.1
1.2
1
1.3
3
1
2
6
5
4
TORQUE SEQUENCE
FOLLOW-ON TASKS:
Install
fuel injection return hoses (TM 9-2320-387-24-1).
Install
rocker arm shafts and pushrods (TM 9-2320-387-24-2).
Install
right intake manifold (TM 9-2320-387-24-2).
Install
right exhaust manifold (TM 9-2320-387-24-1).
Install
water crossover (para. 3-79.1).
Install
glow plugs (TM 9-2320-387-24-1).
Install
fuel injection nozzles (TM 9-2320-387-24-2).
15-13