TB 9-2320-335-13&P
3-26. FUEL TANK SUPPLY AND RETURN LINES REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Tools
Equipment Condition
General mechanic's tool kit:
Engine right splash shield removed
automotive (Appendix B, Item 1)
Materials/Parts
General Safety Instructions
Two locknuts (Appendix A, Item 77)
Do not perform this procedure near fire, flames, or
sparks.
Manual References
TM 9-2320-387-10
Maintenance Level
TM 9-2320-387-24P
Unit
WARNING
Diesel fuel is highly flammable. Do not perform this procedure
near fire, flames, or sparks. Severe injury or death may result.
a. Removal
CAUTION
Cover or plug all open hoses and connections immediately after
disconnection to prevent contamination. Remove all plugs prior to
connection.
NOTE
Have drainage container ready to catch fuel.
1.
Loosen four clamps (7) and disconnect hoses (6) from fuel tank return and supply lines (8).
2.
Remove two locknuts (1), capscrews (5), washers (4), clamps (3), and return and supply lines (8)
from front body bracket (2) and rear body bracket (10). Discard locknuts (1).
3.
Remove three clips (9) from fuel supply and return lines (8).
b. Installation
1.
Install return and supply lines (8) on front body bracket (2) and rear body bracket (10) with two
clamps (3), washers (4), capscrews (5), and locknuts (1).
2.
Connect supply and return lines (8) to four hoses (6) and tighten clamps (7).
3.
Secure fuel supply and return lines (8) together with three clips (9).
3-16