TB 9-2320-335-13&P
Section II. LUBRICATION INSTRUCTIONS
2-6. SCOPE
This appendix gives lubrication requirements for the REV vehicles which are the responsibility of the
operator/crew.
2-7. GENERAL LUBRICATION REQUIREMENTS
a. Maintaining Lubricant Levels. Lubricant levels must be checked as specified in the PMCS and table
1-2, Lubrication. Steps must be taken to replenish and maintain lubricant levels.
WARNING
Drycleaning solvent P-D-680 is TOXIC and flammable. Wear
protective goggles and gloves, use only in well-ventilated area,
avoid contact with skin, eyes, and clothes, and do not breathe
vapors. Keep away from heat and flame. Never smoke when
using solvent. The flashpoint for type I drycleaning solvent is
100F (38C), and for type II, is 138F (59C). Failure to comply
may result in injury or death to personnel.
If personnel become dizzy while using cleaning solvent,
immediately get fresh air and medical help. If solvent contacts
skin or clothes, flush with cold water. If solvent contacts eyes,
immediately flush eyes with water and get medical attention.
b. Cleaning Fittings Before Lubrication. Clean parts with drycleaning solvent P-D-680 or
equivalent. Dry before lubricating.
NOTE
Dotted arrow points indicate lubrication on both sides of the equipment.
c. Lubrication After Fording. Following fording operation, lubricate all fittings below fording depth
and check submerged gear boxes for presence of water.
d. Lubrication After High-Pressure Washing. After a thorough washing, lubricate all grease
fittings and oil can points outside and underneath vehicle.
e. Localized Views. A reference to the appropriate localized view is given after most
lubrication entries.