ELECTRICAL CONNECTIONS
NOTE: Steps 1 through 15 may be performed prior to
armor installation to ease air conditioner installation.
1. Disconnect battery.
2. Remove center firewall panel and panel near accelerator
4. Connect orange power wire to 24 VDC power stud. See
pedal to expose electrical compartment. See figure 1.
figure 3.
5. Connect PosiLock "T" splice to ignition switch controlled 12 volt
volt power wire #18. Connect green wire from power relay
harness to PosiLock "T" splice. See figure 4
3. Locate RD-6-5309-0 power relay harness in electrical kit.
Attach power relay and ground wires to existing screws
in electrical panel. Secure fuse holder with nylon tie. See
figure 2.
RD-2-4663-0 (REV --)
PAGE 11
M915A2
