EVAPORATOR MOUNTING
1. Inside cab, remove four bolts from top rear surface. Save
4. Locate RD-5-4654-0 front evaporator bracket. Using new
washers. See figure 1
longer bolts from kit, inch thick washers, original washers
and locktite, loosely attach front evaporator bracket to
ceiling as shown in figure 4. Place inch thick washers
between bracket and ceiling armor. Hardware sequence
should be; bolt, original washer, bracket then inch thick
washer. Do not tighten yet.
2. Locate RD-2-4655-0 rear evaporator bracket and RD-
2-4534-0 evaporator mount kit. Install rear evaporator
bracket as shown in figure 2 using new longer bolts
and original washers. Install but do not tighten drivers'
side bolt. Use locktite and torque to 15 Lbs/Ft per armor
installation instructions.
3. Remove two top center bolts. Save washers. See figure 3
RD-2-4663-0 (REV --)
PAGE 4
M915A2