TB 9-2320-302-13&P-2
1.) First remove the armor panel from the Driver Side Kick Panel Frame. Then
position the frame forward of the Driver Door as shown, aligning the slotted
angle brackets to the mating brackets on the Door Support Frame.
2.) OPTION 1: Use a provided 3/8" bolt, lock washer, and flat washer to secure
the upper bracket to the Door Support Frame.
3.) Use a proved 3/8" bolt, two flat washers (one on the front side, one on the
back) and a metal locknut to secure the bottom bracket to the Door
Support Frame.
4.) Align drill a 3/8" hole through the
angle tab on the lower-front corner of
the frame and the A-Pillar of the
truck cab.
6.) Slide the Driver Side Kick Panel
5.) Use a proved 3/8" bolt, two flat
Armor Panel into the top of
washers (one on the front side, one
the frame.
on the back) and a metal locknut to
secure the bracket to the vehicle.
Repeat this installation procedure for
Tighten all hardware to final torque.
the Passenger Side Kick Panel Armor.
OPTION 2: Weld Side Kick Panel Frame
to the Door Support Frame.
ArmorWorks
0038 00-42
