TB 9-2320-302-13&P-2
6.) Bolt armor under driver and passenger sides
7.) Place two 2X4's across truck frame and place armor
on the supports
8.) Guide armor with the two support beams and align in the middle of the underbody
so bolts on the panels under passenger and driver side align with the middle ar-
mor panel. Add nuts, flat washers and lock washers.
9.) Insert shifter cables if removed earlier and slowly Jack truck up
again and remove 4X4 block
10.) Slowly lower cab down with jack (or overhead crane if used)
11.) Reinstall nuts on rear vibration mount and tighten. If needed trim the back corner
between the brackets.
ArmorWorks
0038 00-31