TB 9-2320-302-13&P-2
PREPARATION:
1.) For installation it is necessary to jack up the rear of the cab or
utilize a crane if available.
2.) Remove the nuts from the rear vibration mounts.
3.) Unsnap cables under driver and passenger sides. Remove canon plug on drivers side.
4.) Insert a 4X 4 block as shown.
*NOTE: If your vehicle has a shifter cable
remove from shifter side and feed
through opening in center panel.
INSTALLATION:
2.) Use hole saw to drill a 1-1/8" hole into
1.) Place templates over floor mats and
the seat mounting pedestal
drill holes accordingly.
3.) Insert mine blast mounting bracket in
the back drill holes on underbody
4.) Feed electrical cord through armor
5.) Insert stud plates through armor
ArmorWorks
0038 00-30