TB 9-2320-302-13&P-1
CAB SUPPORT REINFORCEMENT REPLACEMENT - CONTINUED
0017 00
REMOVAL - CONTINUED
5.
Remove two nuts (9), star washers (10), washers (11),
8
bolts (8), and isolators (7) from cab support reinforce-
ment (2).
7
2
8
7
9,10,11
417-155
9,10,11
CLEANING AND INSPECTION
Clean and inspect all parts IAW General Maintenance Instructions (WP 0011 00).
INSTALLATION
1.
Install two isolators (7), bolts (8), washers (11), star washers (10), and nuts (9) on cab support reinforcement (2).
WARN I N G
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-
sonnel.
2.
Use lifting device to raise rear of cab enough to install cab support reinforcement (2) on frame.
3.
Install two rubber insulators (3) on vehicle frame.
4.
Install cab support reinforcement (2) on rubber insulators (3).
5.
Install two clamp bars (4), washers (5), and bolts (6) on cab support reinforcement (2). Tighten to 120 ft-lb (160 Nm).
6.
Remove lifting device from vehicle.
7.
Connect air line (1) to air tank.
END OF WORK PACKAGE
0017 00-3/(0017 00-4 Blank)
