II106700-7
Rev. -
WARNING
WARNING
THE EDGES OF THE METAL ARMOR PANELS MAY BE SHARP.
PROTECTIVE GLOVES SHOULD BE WORN BY THE INSTALLATION TEAM
TO PREVENT PERSONAL INJURY.
THE HEMTT ARMOR COMPONENTS ARE HEAVY ITEMS THAT REQUIRE
MORE THAN ONE PERSON AND / OR APPROPRIATE MATERIAL
HANDLING EQUIPMENT (HOIST, FORKLIFT, ETC.) FOR HANDLING. THE
WEIGHTS OF THE COMPONENTS BEING INSTALLED ARE SUFFICIENT TO
CAUSE SERIOUS INJURY OR LOSS OF LIFE. CARE MUST BE TAKEN
DURING INSTALLATION TO PREVENT INJURY.
HOISTING OPERATIONS HAVE INHERENT HAZARDS THAT CANNOT BE
MECHANICALLY SAFE-GUARDED. PERSONNEL ARE REQUIRED TO
WEAR HARD HATS AND SAFETY SHOES DURING INSTALLATION TO
PREVENT PERSONAL INJURY.
CAUTIION
CAUT ON
During the application of paint or the re-application of paint, care must be taken
to prevent covering up installation aid markings [THIS SIDE OUT, up arrows (↑),
etc.]. These installation aid markings must be protected during paint application
by using masking tape, paper, etc.
NOTE
Adjust the installed kit components, as necessary, prior to securing / tightening
the attachment hardware.
Install Armor Kit, Windshield, HEMTT, P/N 106701-4
CAUTIION
CAUT ON
The interior surface of the ballistic transparency (armored window) is plastic.
Clean only with a normal, NON-ABRASIVE glass cleaner or mild soap and water
(Ref. TM 9-2320-280-10). DO NOT use solvents or high-alkaline cleaners on the
ballistic transparency. DO NOT contact the inside surface of the ballistic
transparency with cleaning instruments, squeegees, or other sharp objects that
could cause damage to the surface. DO NOT use a scraper of any kind to remove
frost or ice from the inside surface of the ballistic transparency. DO NOT use any
kind of insect repellant on or anywhere near the ballistic transparency.