II106700-5
Rev. B
Page 35
h) Pre-fit the Windshield Frame Assembly on the vehicle, as shown in Figure 18.
Adjust the Side and Bottom Brackets as needed to line up the studs on the
Windshield Frame. Use caution to avoid damage to the studs. DO NOT hammer the
studs into position on the brackets. Remove the Windshield Frame Assembly and
tighten the set screws in the Side and Bottom Windshield Brackets.
Figure 18. Position the Windshield Armor Frame into the cab windshield opening.
i)
To create an environmental seal between the Vehicle Cab and Windshield Frame
apply the Urethane Sealant (P/N 104302-1) and the Ribbon Sealer (P/N 104303-1)
as shown in Figure 19. If required, use additional sealant from the Front and Side
Armor Kits.
j)
Attach the Windshield Frame Assembly to the vehicle as previously done in Step (g)
using thirty-six (36) 0.250-in. self-locking nuts and thirty-six (36) 0.250-in. ID
washers. Apply light oil to the studs prior to installation of the nuts. Torque to 6 ft-lb.
k) From the inside of the cab, tighten the Set Screws on the Top Windshield Brackets
(P/N 106734-2 or -6-103).
l)
Install the "L" Brackets (P/N 106746-1-103) using the fasteners, as shown in
Figure 20. Apply light oil to the studs prior to installation of the nuts. Torque to 6 ft-lb.
