TM 9-2320-302-34
0080 00-36
FORWARD-REAR AXLE DIFFERENTIAL CARRIER REPAIR - CONTINUED
0080 00
ASSEMBLY - CONTINUED
102.
Lower input shaft (13) and remove lifting device.
103.
Tighten seven cap screws (10) to 75-95 lb-ft (100-130 Nm). Rotate input shaft (13) in each direction to ensure bearings
are installed correctly.
104.
Remove lock nut (8), 0.5 in (12.7 mm) assembly spacer (70), and yoke (9).
105.
Install new oil seal (29), yoke (9), and lock nut (8). Using pinion holding bar, tighten lock nut to 450-600 lb-ft (610-815
Nm).
106.
Rotate input shaft (13) and push yoke (9) toward differential carrier (1) to ensure input shaft is at bottom of travel.
107.
Install dial indicator with point on end of input shaft (13). Zero dial indicator.
108.
Using pry bar, pry up on flange of yoke (9) and read dial indicator. Acceptable reading is 0.002-0.008 in (0.05-0.2mm).
10
9
13
8,70
29