PISTON AND CYLINDER ASSEMBLY MAINTENANCE - CONTINUED
INSTALLATION - CONTINUED
Install connecting rod cap (5) and lower connecting rod bearing shell (6) on connecting rod (12).
Ensure connecting rod bolt has not turned in connecting rod before connecting rod cap nut is tightened to
prevent damage to equipment.
Install two connecting rod cap nuts (4). Tighten cap nuts alternately to 118-137 lb-ft (160-185 Nm). Check connecting
rod side clearance by moving connecting rod from crank neck. If there is no clearance, check bearing installation.
Install remaining piston and rod assemblies in same manner.
Install oil pump (WP 0029 00).
Install cylinder head (WP 0018 00).
END OF WORK PACKAGE