TM 9-2320-302-34
0041 00-19
PISTON AND CYLINDER ASSEMBLY MAINTENANCE - CONTINUED
0041 00
INSTALLATION - CONTINUED
CAUTION
Number stamped on connecting rod indicates cylinder it should be installed in. Number must be on oil
cooler side of cylinder block when installing connecting rod to prevent damage to equipment.
NOTE
Do not allow piston to slide out of bottom of piston ring compressor
30.
Place piston ring compressor (32) and connecting rod and piston assembly (9) over cylinder to be serviced. Position pis-
ton ring compressor squarely on cylinder liner (3) flange.
CAUTION
Do not force connecting rod and piston assembly into cylinder liner as oil control ring expander applies con-
siderable force on oil control ring. Use care to prevent ring breakage.
31.
Push connecting rod and piston assembly (9) into cylinder liner by hand until piston is free of piston ring compressor
(32).
32.
Remove piston ring compressor (32).
9
3
32