[b] If terminals and connectors are not damaged, reprogram the ECM.
Refer to section 15.3.10.
ECM Engine Harness Connector
Check ECM Connectors
Perform the following steps to check the ECM connectors.
1. Check terminals at the ECM engine harness connector (both sensor and harness side)
for damage: bent, corroded and unseated pins or sockets. Check terminals R2 and Y2
of the ECM connector. See Figure 15-8.
[a] If terminals or connectors are damaged, repair them. Refer to section 15.3.10.
All information subject to change without notice.
6SE497 9709 Copyright © 1997 DETROIT DIESEL CORPORATION