[b] If the terminals and connectors are damaged, repair them. Refer to section 15.3.10.
Temperature Sensor Circuits
Check Oil Temperature Sensor Connectors
Perform the following steps to check the OTS connectors.
1. Check terminals at the OTS connector (both sensor and harness side) for damage: bent,
corroded and unseated pins or sockets. See Figure 15-4.
[a] If terminals or connectors are damaged, repair them. Refer to section 15.3.10.
All information subject to change without notice.
6SE497 9709 Copyright © 1997 DETROIT DIESEL CORPORATION