1.
2.
3.
4.
5.
TM 9-2320-363-34-2
NOTE
The magnetic clutch assembly consists of the pulley rotor assembly and field coil assembly.
USING CLUTCH HOLDING TOOL TO KEEP PULLEY FROM ROTATING, REMOVE PULLEY ROTOR
RETAINING BOLT (1) AND WASHER (2) FROM CENTER OF PULLEY ROTOR ASSEMBLY (3).
INSTALL CLUTCH REMOVER IN HUB OF PULLEY ROTOR ASSEMBLY (3).
C A U T I O N
Do not try to remove pulley rotor assembly by prying or hammering.
Failure to follow this caution could result in equipment damage.
TIGHTEN CLUTCH REMOVER TO PULL PULLEY ROTOR ASSEMBLY (3) OFF COMPRESSOR SHAFT
(4).
DISCONNECT FIELD COIL ELECTRICAL LEAD (5).
REMOVE FOUR BOLTS (6) AND FIELD COIL ASSEMBLY (7) FROM COMPRESSOR (8).
Use general cleaning methods to clean all parts (page 2-30).
Inspect all parts for wear or damage.
1.
POSITION FIELD COIL ASSEMBLY (7) ON COMPRESSOR (8) AND INSTALL FOUR BOLTS (6).
TORQUE BOLTS TO 96 LB-IN.(1080 N.cm).
2.
INSTALL PULLEY ROTOR ASSEMBLY (3) ON COMPRESSOR SHAFT (4) TAKING CARE TO
PROPERLY ALIGN AND SEAT SHAFT AND HUB KEYWAYS.
3.
INSTALL WASHER (2) AND PULLEY ROTOR RETAINING BOLT (1). TORQUE RETAINING BOLT TO
20 LB-FT (27 N.m).
4.
TURN PULLEY ROTOR ASSEMBLY (3) BY HAND TO MAKE SURE IT MOVES FREELY WITHOUT
INTERFERENCE WITH FIELD COIL ASSEMBLY (7).
5.
CONNECT FIELD COIL ELECTRICAL LEAD (5).
6.
VERIFY CLUTCH ENGAGES WHEN PROPER VOLTAGE IS APPLIED.
NOTE
Follow-on Maintenance:
Install air conditioner compressor (page 11.1-9).
Change 1
26-3
