9.
10.
TM 9-2320-363-34-2
INSTALL NEW GASKET (16), COVER ASSEMBLY (17), AND FOUR SCREWS (18).
INSTALL TWO BEARINGS (19) AND SPACER (20) IN INPUT GEAR (21).
11.
C A U T I O N
Make sure all bearings, races, and gear are properly alined as shaft is
installed. Failure to do so may cause damage to equipment.
NOTE
Install shaft with slotted end up and toward cover assembly.
INSTAL SHAFT (22), THIN RACE (23), BEARING (24), THICK RACE (25), INPUT GEAR (21), THICK
RACE (26), BEARING (27), THIN RACE (28), AND SETSCREW (29).
24-5/(24-6 Blank)
