TM 9-2320-363-34-2
FORWARD-REAR AXLE DIFFERENTIAL CARRIER REPAIR (CONT)
ASSEMBLY
W A R N I N G
Forward-rear axle differential carrier weighs 1,160 lb (526 kg). Attach suitable
floor jack prior to assembly to prevent possible injury to personnel.
NOTE
If installing new ring gear and drive pinion, perform steps 1 thru 6.
Replace ring gear and drive pinion as matched set. Gear set match number is
on gear head of drive pinion and front face or outer diameter of ring gear.
Pinion cone variation number is used to adjust depth of pinion in differential
carrier. Pinion cone variation number is on end of gear head of drive pinion or
outer diameter of ring gear.
1.
RECORD NEW PINION CONE VARIATION NUMBER.
2.
RECORD OLD PINION CONE VARIATION NUMBER.
3.
IF OLD PINION CONE VARIATION NUMBER IS +, SUBTRACT NUMBER FROM SHIM PACK
THICKNESS IN DISASSEMBLY STEP 47.
4.
IF OLD PINION CONE VARIATION NUMBER IS -,
ADD NUMBER TO SHIM PACK THICKNESS IN
DISASSEMBLY STEP 47.
5 .
IF NEW PINION CONE VARIATION NUMBER IS +, ADD NUMBER TO SHIM PACK THICKNESS
DETERMINED IN STEP 3 OR 4.
6.
IF NEW PINION CONE VARIATION NUMBER IS -,
SUBTRACT NUMBER FROM SHIM PACK
THICKNESS DETERMINED IN STEP 3 OR 4.
17-18
