TM 9-2320-363-34-2
CYLINDER HEAD REPAIR (CONT)
24.
25.
26.
27.
NOTE
Replace dowels and plugs only if necessary.
Dowel removal procedure is the same for round, diamond, or hollow dowels.
Cover exposed areas to guard against welding sparks.
FABRICATE PIECE OF SHEET BRASS (24) WITH HOLE LARGE ENOUGH TO FIT OVER DOWEL
BEING REMOVED.
TACK-WELD FLAT WASHER (25) TO TOP OF DOWEL AS SHOWN.
TACK-WELD NUT (26) TO FLAT WASHER (25). MAKE SURE THREAD OF NUT (26) MATCHES
THREAD OF SLIDE HAMMER SHAFT (27).
THREAD SLIDE HAMMER SHAFT (27) INTO NUT (26) AND REMOVE DOWEL.
12-16
