TM 9-2320-363-34-2
26. TIGHTEN PISTON PIN BOLTS TO 33 LB-FT (45 N.m).
27. TURN PISTON PIN BOLTS AN ADDITIONAL 60 DEGREES (TWO POINTS ON 12-POINT BOLT).
NOTE
Steps 28 and 29 are required to reduce joint friction for more consistent
bolt-clamp load.
28. LOOSEN PISTON PIN BOLTS AND TIGHTEN TO 33 LB-FT (45 N.m).
29. TURN PISTON PIN BOLTS AN ADDITIONAL 60 DEGREES (TWO POINTS ON 12-POINT BOLTS).
30. REMOVE CONNECTING ROD AND PISTON ASSEMBLY (24) FROM HOLDING FlXTURE (25).
31. PLACE PISTON ASSEMBLY (26), DOME DOWN, IN CLEAN PAN. COAT PISTON ASSEMBLY (26)
LIBERALLY WITH CLEAN ENGINE LUBRICATING OIL.
32. REPEAT STEPS 8 THRU 31 FOR REMAINING CONNECTING ROD AND PISTON ASSEMBLIES.
33. REMOVE TWO CONNECTING ROD CAP NUTS (27) AND CONNECTING ROD CAP (28).
12-163