TM 9-2320-363-34-2
C A U T I O N
Be careful when removing rear crankshaft sleeve bearing to prevent damaging
bearing bore.
32. USING BRASS DRIFT AND HAMMER, REMOVE REAR CRANKSHAFT SLEEVE BEARING (53) BY
TAPPING AROUND INSIDE EDGE OF SLEEVE, DRIVING CRANKSHAFT REAR SLEEVE BEARING
(53) AWAY FROM FUEL PUMP MOUNTING FLANGE.
C L E A N I N G
Use general cleaning methods to clean all parts (page 2-30).
I N S P E C T I ON
Inspect drive shaft for galling, pitting, cracks, or other damage. Replace if damaged.
R E P A I R
Use general repair methods to repair damaged parts (page 2-33).
1.
POSITION REAR COVER (1) FACE DOWN ON PRESS BED.
2.
POSITION CRANKSHAFT REAR SLEEVE BEARING (2) IN BORE OF REAR COVER (1) WITH SLOT
IN REAR SLEEVE BEARING (2) PERPENDICULAR TO CRANKSHAFT VERTICAL CENTERLINE.
3.
PRESS CRANKSHAFT REAR SLEEVE BEARING (2) IN BORE OF REAR COVER (1) FLUSH WITH
THRUST WASHER SEAT.
12-127
