TM 9-2320-363-34-1
ENGINE REPLACEMENT (CONT)
W A R N I NG
Do not place finger in hole of engine flywheel housing while engine is being
barred over. To do so could result in serious injury to personnel.
C A U T I O N
Step 13 must be followed for barring over engine. Any other method could
cause damage to equipment.
If bolts are dropped in engine flywheel housing, retrieve immediately. Failure
to do so could result in damage to equipment.
13. HAVE ASSISTANT BAR ENGINE (8) OVER USING ACCESSORY DRIVE (33). LOCATE AND ALINE
HOLES AND INSTALL BOLT (34) THRU HOLE IN ENGINE FLYWHEEL HOUSING (35). REPEAT
UNTIL 12 BOLTS (34) HAVE BEEN INSTALLED HAND-TIGHT.
14. TIGHTEN 12 BOLTS (34) TO 96-115 LB-FT (131-156 N.m).
3-30
