TM 9-2320-363-34-1
8.
TIGHTEN FOUR NUTS (15 AND 20) ON TWO REAR ENGINE MOUNTS (16 AND 21).
9.
10.
11.
12.
C A U T I ON
Transmission must be seated squarely against engine flywheel housing to
prevent damage to equipment.
INSTALL TWO BRACKETS (29), 12 NEW LOCK WASHERS (30), AND 12 SCREWS (31) IN
TRANSMISSION (1 0), TIGHTEN SCREWS HAND-TIGHT.
TIGHTEN FOUR SCREWS (31 ) 90 DEGREES APART TO 40 LB-FT (55 N.m).
TIGHTEN REMAINING SCREWS (31) TO 40 LB-FT (55 N.m).
REMOVE PLUG (32) AND ROTATE TORQUE CONVERTOR TO ALINE HOLES IN FLEX PLATE
WITH HOLES IN TORQUE CONVERTOR.
3-29
