TM 9-2320-363-34-1
NOTE
Procedure is the same for both vehicles except as noted.
1.
INSTALL FRONT ENGINE MOUNT SUPPORT (1).
NOTE
Step 2 is for M915A2 only.
2.
INSTALL FOUR SPACERS (2).
3.
LEFT SIDE: INSTALL TWO WASHERS (3), TWO CAPSCREWS (4), TWO WASHERS (5), AND TWO
NUTS (6) ON FRAME (7).
4.
REPEAT STEP 3 FOR RIGHT SIDE.
NOTE
M915A2 only: Make sure spacers installed during step 2 do not slip out of place.
If spacer is not present, frame will not be in line to allow installation of front
crossmember.
5.
INSTALL SCREW (8), THREE WASHERS (9), THREE CAPSCREWS (10), FOUR WASHERS (11),
AND FOUR NUTS (12).
NOTE
Follow-on Maintenance:
Install front engine mount adapter (page 3-46).
Install front crossmember (page 8-10).
Install front quick-release valve (TM 9-2320-363-20).
8-9