TM 9-2320-363-34-1
1.
APPLY OIL AND INSTALL NEW SEAL RING (11) (DDEC II) OR NEW GASKET (11.1) (DDEC III)
ON POWER STEERING PUMP (6).
C A U T I O N
Aline power steering drive coupling (9) on air compressor drive gear and power
steering pump gear properly. Failure to do so may cause damage to engine
components.
2.
INSTALL POWER STEERING DRIVE COUPLING (9) ON AIR COMPRESSOR DRIVE GEAR (10)
AND POWER STEERING GEAR (12).
3.
4.
INSTALL POWER STEERING PUMP (6) ON GEAR CASE COVER (3).
INSTALL SIX NEW LOCK WASHERS (8) AND SIX CAPSCREWS (7) ON POWER STEERING
PUMP (6). TIGHTEN CAPSCREWS TO 22-28 LB-FT (30-38 N.m) USING CRISSCROSS PATTERN
STARTING WITH BOTTOM-LEFT-CORNER CAPSCREW.
5.
IF DISCONNECT, CONNECT STEERING GEAR HOSE (4) AND POWER STEERING RESERVOIR
HOSE (5) TO POWER STEERING PUMP (6).
6.
IF REMOVED, INSTALL CLAMP (2) AND SCREW (1) ON GEAR CASE COVER (3).
NOTE
Follow-on Maintenance:
Fill power steering reservoir (TM 9-2320-363-20).
Change
1
7-3
