TM 9-2320-363-34-1
INJECTOR WIRING HARNESS REPLACEMENT (CONT)
C A U T I O N
Do not pull on injector wires or terminals when installing harness in cylinder
head to prevent damage to equipment.
NOTE
All connectors should reach terminals without strain or repositioning of injector
wire when harness is installed correctly.
1.
FEED HARNESS (1) INTO CYLINDER HEAD HARNESS HOLE (2) AT REAR OF CYLINDER HEAD
(3).
2.
POSITION INJECTOR WIRES (4) IN CYLINDER HEAD (3) SO WIRES FOLLOW INSIDE RAIL OF
CYLINDER HEAD ON OIL COOLER SIDE OF ENGINE UNDER ENGINE RETARDER ASSEMBLY.
3.
BEGIN WITH TWO LONGEST INJECTOR WIRES AND INSTALL TERMINALS (5) OVER SCREWS (6)
ON NO. 1 (FRONT) INJECTOR. TIGHTEN SCREWS TO 12-17 LB-IN. (1.25-1.92 N.m).
4.
FOLLOW SAME PROCEDURE FOR INSTALLING REMAINING INJECTOR WIRES.
4-4
