TM 9-2320-363-34-1
TRANSFER CASE YOKE AND SEAL REPLACEMENT
This task covers:
a. Removal
b. Cleaning
c. Inspection d. Repair
e. Installation
Applicable Configuration:
Equipment Description:
All except M915A2
Reference
Condition Description
Tools and Special Equipment:
Shop Equipment, SC 4910-95CL-A31
TM 9-2320-363-20
Driveline Removed
TM 9-2320-363-20
Transfer Case Oil Drained
Tool Kit, SC 5180-90-CL-N05
Materials/Parts:
General Safety Instructions:
Seal, Oil
P/N 55079AX
Grease,
Appendix B, Item 26
Automotive and
Artillery (GAA)
Adhesive-Sealant,
Appendix B, Item 3
Silicone
References:
TM 9-2320-363-20
W A R N I N G
Adhesives, solvents, and sealing compounds
can burn easily, can give off harmful vapors,
and are harmful to skin and clothing. To avoid
injury or death, keep away from open fire and
use in well-ventilated area. If adhesive, solvent,
or sealing compound gets on skin or clothing,
wash immediately with soap and water.
N O T E
Procedure is the same for all yokes and oil seals.
1 .
REMOVE TWO SCREWS (1) AND LOCK PLATE (2) OR ONE SCREW (7) AND LOCK PLATE (8).
2.
REMOVE YOKE (3) FROM SHAFT (4).
3.
REMOVE AND DISCARD OIL SEAL (5) FROM BEARING CAP (6).
Use general cleaning methods to clean all parts (page 2-30).
Inspect all parts for wear or damage.
3-274
Change 1
