TM 9-2320-363-34-1
NOTE
Before oil seal installation, direction of arrow on oil seal should match engine
rotation.
5.
CAREFULLY INSTALL NEW OVERSIZED CRANKSHAFT OIL SEAL (5) ON NEW WEAR SLEEVE (6)
FROM CHAMFERED END OF SLEEVE. POSITION OIL SEAL (5) IN MIDDLE OF SLEEVE (6) WITH
CASE SIDE OF SEAL AWAY FROM CHAMFERED END OF SLEEVE.
6.
POSITION AND INSTALL OIL SEAL AND SLEEVE ASSEMBLY IN OIL SEAL INSTALLER HOUSING
(7) WITH SEAL CASING AGAINST INSTALLER HOUSING.
7.
PLACE OIL SEAL INSTALLER HOUSING (7) WITH OIL SEAL AND SLEEVE ASSEMBLY OVER
CENTER SCREW (8) AND TWO GUIDE STUDS (4) AND POSITION SLEEVE (6) AGAINST FRONT
OF CRANKSHAFT.
8.
INSTALL THRUST BEARING (9) ON CENTER SCREW (8) WITH LETTERED SIDE OF BEARING
AGAINST OIL SEAL INSTALLER HOUSING (7).
9.
INSTALL NUT (10) ON CENTER SCREW (8). TIGHTEN NUT UNTIL CRANKSHAFT FRONT OIL
SEAL AND SLEEVE ARE SEATED FIRMLY.
10. REMOVE OIL SEAL INSTALLER NUT (10), THRUST BEARING (9), INSTALLER HOUSING (7),
GUIDE STUDS (4), AND INSTALLER BASE (2).
NOTE
Follow-on Maintenance:
Install front mount (page 3-46).
Install vibration damper (page 3-122).
Install tachometer cable (TM 9-2320-363-20).
Install power steering pump (page 7-2).
Install accessory drive (page 3-126).
Install alternator (TM 9-2320-363-20).
3-233
