TM 9-2320-363-34-1
CRANKSHAFT FRONT OIL SEAL REPLACEMENT (CONT)
NOTE
Make sure screws are evenly snug against oil seal remover, but not
overtightened or stripped in seal case.
1.
INSTALL OIL SEAL REMOVER (1) OVER END OF CRANKSHAFT AND AGAINST GEAR CASE
COVER (2). INSTALL SIX SELF-TAPPING SCREWS (3).
2.
INSTALL THREE BOLTS (4) IN OIL SEAL REMOVER (1) UNTIL BOLTS (4) CONTACT GEAR CASE
COVER (2).
NOTE
If self-tapping screws strip out of seal case, remove six self-tapping screws and
three bolts. Rotate oil seal remover one-half distance between existing screw
holes in seal case and repeat steps 1 thru 3.
3.
WORK CLOCKWISE AND TURN THREE BOLTS (4), ONE AT A TIME, ONE FULL TURN UNTIL OIL
SEAL IS REMOVED.
3-228
