STEP/SEQUENCE
RESULT
WHAT TO DO NEXT
TM 9-2320-363-20-1
Section 4
TROUBLESHOOTING CHARTS
E.
FLASH CODE:
82. - CRANKCASE MONITOR (CCM) SIGNAL VOLTAGE LOW (CONTD)
J1587 CODE:
P984 - OIL LEVEL CIRCUIT FAILED LOW
P101 -4CRANKCASE PRESSURE CIRCUIT FAILED LOW
82-8
Check for Open +5 Volt
Line
Turn ignition off.
Less than or
Go to 82-9.
Disconnect engine harness
equal to 5 ohms.
connector at ECM,
Install a jumper wire between
Greater than
The engine +5 Volt line (Ckt #416)
sockets A and C of CCM
5 ohms or open.
is open. Repair open.
harness connector.
Then go to 82-30.
Read resistance between sockets
W1 and Y2 on engine harness
connectors.
82-9
Check for Short
Remove jumper wire.
Less than or
The engine +5 Volt line (ckt #416)
Read resistance between sockets
equal to 10,000 ohms.
is shorted to return line (ckt #452).
A and C on CCM harness
Repair short.
connector.
Then go to 82-30.
Greater than
Go to 82-12.
10,000 ohms or open.
82-10
Check for Short to
Battery
Remove both fuses to ECM.
All readings are
Go to 82-12.
Disconnect vehicle harness
greater than 10,000 ohms
and 6-way power harness
or open.
connectors at ECM.
Read resistance between sockets
Any reading is
A short exists between sockets
N1 of engine harness connector
less than or equal to
where less than 10,000 ohms
and socket B3 of vehicle
10,000 ohms.
resistance was read. Repair
harness connector.
short and reinsert fuses ( or
Also read resistance between
reset breakers). Then go to
socket N1 on engine harness
82-30.
connector and the following
sockets on the 5-way power
harness connector: A, and C.
Change 3 3-345.387
