STEP/SEQUENCE
RESULT
WHAT TO DO NEXT
TM 9-2320-363-20-1
Section 4
TROUBLESHOOTING CHARTS
E.
FLASH CODE:
82 - CRANKCASE MONITOR (CCM) SIGNAL VOLTAGE LOW (CONT'D)
J1587 CODE:
P98-4 - OIL LEVEL CIRCUIT FAILED LOW
P101.4 - CRANKCASE PRESSURE CIRCUIT FAILED LOW
82-4
Check for +5 Volts
Turn ignition off.
Between 4 to
Go to 82-5.
Remove jumper wire.
6 volts.
Connect vehicle harness to ECM.
Turn ignition on.
Less than
Go to 82-8.
Read voltage on CCM harness
4 volts.
connector, socket C (red lead)
to socket A (black lead).
Greater than
Go to 82-10.
82-5
Check for Signal Open
Turn ignition off.
Less than or
Go to 82-11.
Disconnect engine harness
equal to 5 ohms.
connector at ECM.
Install a jumper wire between
Greater than
Signal line (ckt #906) is open.
sockets A and B of CCM
5 ohms or open.
Repair open. Then go to 82-30.
harness connector.
Read resistance between sockets
N1 and Y2 on engine harness
connectors.
82-6
Check for Short
Remove jumper wire.
Less than or
Signal line (ckt #906) is shorted
Disconnect engine harness
equal to 10,000 ohms
to return line (ckt #452) or
connector at ECM.
battery ground. Repair short.
Read resistance between sockets
Then go to 82-30.
A and B on CCM harness
connector.
Greater than
Go to 82-12.
Also read resistance between
10,000 ohms or open
socket B and a good ground.
on both readings.
82-7
Check ECM Connectors
Check terminals at ECM engine
Terminals and
Replace ECM. Then go to 82-30.
harness connector (both ECM
connectors are okay.
and harness side) for damage;
bent, corroded and unseated
Problem found.
Repair terminals/connectors.
pins or sockets. Especially W1,
Then go to 82-30.
N1 and Y2 terminals and pins at
ECM.
Change 3 3-345.385
