TM 9-2320-363-20-1
Section 4
TROUBLESHOOTING CHARTS
FLASH CODE:
82
DDR DISPLAY:
CRNKCSE PRESS SENSOR INPUT VOLTAGE LOW
SAE J1587 CODE:
PID: 101 FMI: 4
Indicates that the Crankcase Pressure Sensor input to the ECM has dropped below 5% (normally < 0.25 volts) of the
sensor supply voltage. This diagnostic condition is typically:
(1)
open sensor signal circuit
(2)
open sensor +5 volt supply circuit
(3)
sensor signal is shorted to the sensor return circuit or to ground
(4)
sensor +5 volt supply is shorted to sensor return circuit
FLASH CODE:
82
DDR DISPLAY:
DUAL FUEL BOI INPUT VOLTAGE LOW
SAE J1587 CODE:
SID: 020 FMI: 4
Indicates that the Dual Fuel (Diesel/Natural Gas) ECM BOI output control signal to the DDEC III ECM has dropped
below the calibratible minimum level.
FLASH CODE:
83
DDR DISPLAY:
OIL LEVEL HIGH
SAE J1587 CODE:
PID: 098 FMI: 0
Indicates that the Oil Level Sensor has detected that the engine oil level has exceeded the recommended safe
operating range.
FLASH CODE:
83
DDR DISPLAY:
CRANKCASE PRESSURE HIGH
SAE J1587 CODE:
PID: 101 FMI: 0
Indicates that the Crankcase Pressure Sensor has detected that the engine crankcase pressure has exceeded the
recommended safe operating range.
FLASH CODE:
84
DDR DISPLAY:
OIL LEVEL LOW
SAE J1587 CODE:
PID: 098 FMI: 1
Indicates that the Oil Level Sensor has detected that the engine oil level has dropped below the recommended safe
operating range.
FLASH CODE:
84
DDR DISPLAY:
CRANKCASE PRESSURE LOW
SAE J1587 CODE:
PID: 101 FMI: 1
Indicates that the Crankcase Pressure Sensor has detected that the engine crankcase pressure has dropped below
the recommended safe operating range.
FLASH CODE:
85
DDR DISPLAY:
ENGINE OVERSPEED
SAE J1587 CODE:
PID: 190 FMI: 0
Indicates that the engine RPM has exceeded the recommended safe operating range.
3-345.36 Change 3
