page 3-164
page 3-169
page 3-311
Section 4
TROUBLESHOOTING CHARTS
C. START
FIRST CHART FOR DIAGNOSIS OF DDEC-II USING DDR
WARNING: The engine and ignition should always be off before connecting or disconnecting sensors or wiring
harness. Failure to follow this warning could damage the ECM.
STEP/SEQUENCE
START-1 Note "Check
Engine Light
Turn ignition on while at the same
time observing the Check
Engine light.
Be sure there is not a jumper wire
between pins A and M of the DDL
connector and any switch for
flashing out codes should be in
the off position.
START-2 Read Active
Codes Using DDR
Plug DDR into the 12 pin
DDL connector.
Read active codes by selecting
MODE 01 (ACTIVE CODES) on
the DDR.
Read historical codes by selecting
MODE 02 (HISTORICAL CODES)
on the DDR.
Record ail active and
historical codes.
TM 9-2320-363-20-1
RESULT
WHAT TO DO NEXT
Light comes
on and stays on.
Light comes
on for up to 5 seconds,
then goes out.
Light is off.
Erratic or
intermittent light.
A c t i v e c o d e s
Follow appropriate diagnostic
(other than Code 25)
charts for code(s) received.
on DDR.
(See Index on page 3-101).
Active Code 25
and historical Code 51
(other codes may be
present).
Active Code 25 only.
,
DDR display reads
l
"NO DATA BEING
RECEIVED FROM DATA
LINK or "DDEC SYSTEM
NOT RESPONDING.
DDR display is
blank or random.
3-121
