TM 9-2320-363-10
2-38.
CAGE AND UNCAGE BRAKES (Con’t).
(2)
Remove nut (4) washer (5), and release stud (2) from stow-
age pocket (1).
(3)
Remove cap (3) from spring chamber (6).
(4)
Insert cross-pin end of release stud (2) into opening where
cap (3) was removed.
(5)
To engage cross-pin, rotate release stud (2) until cross-pin
end goes into slot inside of spring chamber (6). Turn release stud right ¼ turn; cross-
pin is now engaged.
(6)
Install washer (5) and nut (4) on release stud (2).
(7)
Tighten nut (4) until approximately 3 in. of release stud (2)
shows above nut. Spring brake is fully released.
b. Uncage Brakes.
(1)
Block wheels.
(2)
Remove nut (4) and washer (5) from release stud (2).
(3)
Turn release stud (2) to left ¼ turn and remove release stud
from spring chamber (6).
(4)
Install cap (3) in spring chamber (6).
(5)
Insert release stud (2) into stowage pocket (1) and install
washer (5) and nut (4) on release stud.
2-126
