TM 9-2320-303-10
2-27.
PREPARATION FOR TRANSPORT (Con't).
CAUTION
· Front extendable bumper is for overhead sling use only. It is not
intended to be used to tow or extract a mired vehicle. DO NOT
extend the bumper more than one adjustment hole. ALWAYS have
both pins engaging the bumper and bumper extension on each side.
Failure to follow this caution could result in damage to equipment.
· To avoid damage to cab, always extend bumpers when using a four
point sling lift.
NOTE
Both left and right side bumper extensions are adjusted in the same
manner. Right side is shown.
c.
Remove two retaining pins (1), two flat washers (2), and two straight pins (3)
from front bumper (4).
d.
Position bumper extension (6) in front bumper (4) so straight pins (3) will engage
two inside adjustment holes (5) on bumper extension.
e.
Install two straight pins (3), two flatwashers (2), and two retaining pins (1) in front
bumper (4).
2-83
