TM 9-2320-302-34
0081 00-3
REAR-REAR AXLE DIFFERENTIAL CARRIER REPLACEMENT - CONTINUED
0081 00
INSTALLATION - CONTINUED
WARNING
Adhesives and sealing compounds can burn easily, can give off harmful vapors, and are harmful to skin and
clothing. To avoid injury or death, keep away from open fire and use in well-ventilated area. If adhesive or
sealing compound gets on skin or clothing, wash immediately with soap and water.
CAUTION
Ensure both mating surfaces have been completely cleaned to prevent damage to equipment.
2.
Apply sealing compound around mating surface of axle (6).
3.
Attach suitable hoist and install differential carrier (5) to axle (6) with four flat washers (4) and screws (2) in four corner
locations around differential carrier. Hand tighten screws.
4.
Seat differential carrier (5) and tighten four screws (2) in crisscross pattern.
5.
Repeat step 4 until differential carrier (5) is completely seated. Tighten four screws (2) to 150-230 lb-ft (203-312 Nm).
6.
Install eight flat washers (3) and screws (1). Tighten screws in crisscross pattern to 150-230 lb-ft (203-312 Nm).
7.
Connect intermediate driveline (TM 9-2320-302-20).
8.
Install axle shafts (TM 9-2320-302-20).
9.
Fill axle with oil (TM 9-2320-302-20).
END OF WORK PACKAGE
