TM 9-2320-302-34
0049 00-6
WATER PUMP REPAIR - CONTINUED
0049 00
ASSEMBLY - CONTINUED
5.
Apply a thin film of clean engine lubricating oil to sealing lip of oil seal. Lubricate roller bearing (13) assembly. Care-
fully install square end of water pump shaft (5) through oil seal and position roller bearing assembly in water pump
housing bore (19).
6.
Using large end of bearing and seal installer (18), press roller bearing and shaft assembly (11) in water pump housing
bore (19), until roller bearing (13) is seated against shoulder of water pump housing bore.
7.
Install retaining ring (10) in ring groove (20) of water pump housing bore (19).
NOTE
Ensure retaining ring is fully seated in ring groove.
8.
Place holding fixture (16) on press bed. Install extension tool (21) in holding fixture in contact with adjusting wheel
(22).
NOTE
Ensure water pump shaft is supported while components are being assembled.
9.
Turn water pump housing (4), gear side down, and position water pump shaft (5) over extension tool (21) in holding fix-
ture (16).
10
13
5
19
20
18
11
